Taurus Raging Hunter 350 Legend: Big Revolver, Picky About Ammo

Taurus has stretched its Raging Hunter revolver line into 350 Legend territory, and Shoot ON writer Rob Reaser took the 10.5-inch barrel version hunting-ready to see what the straight-wall cartridge gives up, and gains, out of a big-bore wheelgun.

Snapshot

Reaser tested the Raging Hunter 350 with three factory loads, pairing it with an Aimpoint Acro P-2 red dot. He found the revolver lost roughly 19 percent of the 350 Legend's rifle-barrel velocity, but one load, Federal's now-discontinued Non-Typical 180-grain soft point, printed a 1.975-inch group at 50 yards, the best the gun managed in testing.

Key points

• Chambering: The Raging Hunter 350 is offered in 10.5-, 14-, and now 8-inch barrel lengths, all built on the large-frame Raging Hunter platform with a six-round cylinder.
• Velocity trade-off: Reaser clocked Hornady's 170-grain InterLock at 1773.5 fps from the revolver versus 2353.8 fps from a 26-inch T/C Encore barrel, a drop he attributes to the shorter pistol barrel.
• Load sensitivity: He reported the gun shot poorly with the lighter 165- and 170-grain Hornady loads but favored the heavier 180-grain Federal round, underscoring his point that terminal performance matters more at handgun velocities.
• Trigger: Reaser measured a 3-pound, 4.7-ounce single-action pull and called the factory trigger a standout, with no grit through the break.
• Recoil: He felt the 350 Legend version recoiled comparably to his 44 Magnum Raging Hunter, crediting the frame weight and clamp-on muzzle brake.

Quick take

Reaser frames the Raging Hunter 350 as a short-range, load-dependent hunting tool rather than a plug-and-play setup, one that rewards hunters willing to chase down the right ammunition and accept its limited effective distance.

Read the full story: shoot-on.com